Blade's

What will shorten the life of your diamond blades?

Bigsease302017-04-23T21:46:29+00:00Answer:

What are the causes of a warped or wobbling diamond blade?

Bigsease302017-04-23T22:34:48+00:00Cause 1: Blade is mounted on a defective saw Remedy: Check for bad bearings, bent shaft, or worn mounting arbor. Check clamping discs to make sure they are clean, flat and of correct diameter. Cause 2: Blade runs at improper operating speed Remedy: Make certain that blade shaft is running at recommended RPM to match tenshioned speed of the saw.  For concrete saws, use a tachometer to check and see that engine is at proper speed. Cause 3: Blade collar diameters are not identical.  Blade bands as a result of dropping or twisting Remedy: Use proper size blade collars.

What causes slow diamond blade cutting speeds?

Bigsease302017-04-23T21:45:04+00:00Answer:

What are the causes of diamond blades undercutting?

Bigsease302017-04-23T21:44:21+00:00Answer:

What causes core or segment cracks?

Bigsease302017-04-23T22:33:27+00:00Cause 1: Blade flutters in cut as a result of losing blade tension Remedy:  Tighten the blade shaft nut.  Make sure blade is running at proper tensioned speed and that drive pin is functioning properly. Cause 2: Blade specification is too hard for the material being cut Remedy: Use a softer bond to eliminate stresses which create cracks.